Beko SLGR 30523SS Owner's Manual page 47

INSTALLATION
Warning: Avoid fire hazard or electrical
!
shock. Do not use an adapter plug, an
extension cord, or remove grounding
prong from electrical power cord , have
a qualified electrician install an outlet
near the appliance. Failure to follow this
warning can cause serious injury, fire or
death.
Warning: Risk of Electric Shock or
!
Fire. Grounding through the neutral
conductor is prohibited for new branch
circuit installations (1996 NEC), mobile
homes, and recreational vehicles,
or in an area where local codes
prohibit grounding through the neutral
conductor.
• Before starting any work the electrical
installation, the electrical power to
the range must be shut off while line
connections are being made. Failure to
follow these instructions can result in
death, fire, or electrical shock.
• This appliance is equipped with a
3-prong grounding plug for your
protection against shock hazard and
should be plugged directly into a
properly grounded receptacle. DO NOT
cut or remove the grounding prong
from this plug. For personal safety, the
range must be properly grounded. For
maximum safety, the power cord must
be plugged into an electrical outlet
that is correctly polarized and properly
grounded. If a 2-prong wall receptacle is
the only available outlet, it is the personal
responsibility of the consumer to have
it replaced with a properly grounded
3-prong wall receptacle installed by a
qualified electrician.
Warning: Do not ground to a gas pipe.
!
Caution: Wire sizes and connections
!
must conform with the fuse size and
rating of the appliance in accordance
with the American National Electrical
Code ANSI/ NFPA No. 70-latest edition.
Our company shall not held responsible
i
for any damage caused by using the
appliance without grounded receptacle.
Caution: This range must be electrically
!
grounded in accordance with local
codes, or in their absence, with the
National Electrical Code ANSI/NFPA
No. 70-latest edition in United States.
Installation should be made by a
licensed electrician.
Warning: Risk of electric shock,
!
short circuit or fire by damage
of the main power supply!
The main power supply lead must
not be clamped, bent or trapped or
come into contact with hot parts of
the appliance. If the main power cable
is damaged, it must be replaced by a
qualified electrician.
• This range may be connected by means
of permanent "hard wiring" (flexible
armored or nonmetallic shielded copper
or aluminum cable), or by means of a
power supply cord kit. Only a power
supply cord kit rated at 120/ 240 volts
and 40 or 50 amperes terminating in
tinned leads and marked for use with
ranges shall be used. If a 50 Amper cord
is used it must be marked for use with a
1 3/8 inches (35 mm) diameter opening.
• Amper cord is used it must be marked
for use with a 1 3/8 inches (35 mm)
diameter opening. Cord must have either
3 or 4 conductors to match electric
receptacle (Use copper or Aluminum
Conductors).
Warning: Risk of fire or electrical shock
!
exists if an incorrect size appliance cord
kit is used or the Installation manual or
strain relief clamp are disregarded.
Warning: Do not loosen the nuts which
!
secure the factory-installed range wiring
to the terminal block while connecting
range. Electrical failure or loss of
electrical connection may occur.
19