Uc Laser Ir Control; Troubleshooting - ADJ MICRO 3D II User Instructions

Micro 3D II
The UC Laser IR infrared remote gives you control of various func-
tions (See below). To control the fixture you must aim the remote at
the front of the fixture and be no more than 30 feet away.
The Micro 3D II comes with the Airstream IR remote transmitter.
The transmitter plugs into the headphone jack of your iOS phone
or tablet. To control your IR fixture you must raise the volume to the
maximum on your iOS phone or table and aim the transmitter at the
front of the fixture and be no more than 15 feet away. After you have
purchased the Airstream IR transmitters, the app is a free download
from the app store for your iOS phone or tablet. The app comes with
3 pages of control depending on the IR fixture you are using. Please
see below for IR functions including the corresponding app page.
Works with App page 3.
STAND BY - Pressing this button will blackout the fixture.
PATTERN - Press this button for random rotation.
PATTERN "+" - Press this button for clockwise rotation.
PATTERN "-" - Press this button for counter-clockwise rotation.
SPEED - Press this button for random rotation speed.
SPEED + - Press this button to speed up the rotation.
SPEED - - Press this button to slow down the rotation.
COLOR BUTTONS - Press the color buttons R, G, or R+G to select
your desired color(s). Buttons B, G+B, B+R, and R+G+B are invalid
for this fixture.
STROBE - This button will activate the strobe effect. Press the but-
ton once and hold for strobing.
SOUND - Press this button to activate sound active mode
AUTO FAST - Press this button to activate fast auto mode.
AUTO SLOW - Press this button to activate slow auto mode.
ADJ Products, LLC - www.adj.com - Micro 3D II Instruction Manual Page 10

UC Laser IR Control

Micro 3D II
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning
the internal and external lenses should be carried out periodically to
optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Clean the external optics with glass cleaner and a soft cloth every
20 days.
3. Always be sure to dry all parts completely before plugging the
unit back in.
Cleaning frequency depends on the environment in which the fixture
operates (I.e. smoke, fog residue, dust, dew). In heavy use we recom-
mend cleaning on a monthly basis. Periodic cleaning will ensure lon-
gevity, and crisp beam output.
Micro 3D II
Trouble Shooting: Listed below are a few common problems that
you may encounter, with solutions.
No laser output from the unit;
1. Be sure you have connected your unit into a standard wall
outlet.
2. Be sure that the unit is not in blackout mode.
3. In cold temperature situations it might take the laser a little longer
to produce output. It can take up to 3-5 minutes for the laser to
produce a beam. This is due to the laser diode which is very sen-
sitive.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may
not activate the unit.
ADJ Products, LLC - www.adj.com - Micro 3D II Instruction Manual Page 11
Cleaning
Trouble Shooting