Table of Contents
Advertisement
Available languages
Available languages
Deleting the complete phone book
Ô
¢
¢
(open phone book)
press and hold
¤
Ì
To cancel the delete action press
ing
.
Using several handsets
Registering handsets
Before you can use your handset, you must register it
to the base station. You can register up to four hand-
sets. You must initiate handset registration on the
handset and on the base station.
On the base
¤
Press and hold the paging key
sec.
f
On the handset
¢
|
¢
¢
(open menu)
ADVANCED SET
~
REGISTRATION
(enter current PIN, default: 0000)
The handset is assigned the lowest unassigned inter-
nal number (1–4).
Once the handset has been registered successfully, it
returns to idle mode. The name (default: Gigaset) and
the handset's internal number is shown in the display,
e.g.
.
Gigaset 1
If the handset was not registered successfully, the dis-
play will show
PLS REG H/S
cedure.
Please note
◆
¢
The default system PIN may have been
changed, (
page 19).
◆
¢
The handset name can be changed,
(
page 18).
Deregistering handsets
Please note
Do not deregister handsets unless necessary!
f
¢
Precondition: the handset is in idle mode.
|
¢
(open menu)
¢
ADVANCED SET
~
¢
UNREGISTER
p
(enter current PIN)
¢
(select handset to be deregistered)
A long confirmation tone indicates the successful
deregistration. The handset display will show
.
PLS REG H/S
Ì
(confirm action)
Ó
before press-
Ë
for at least 5
|
¢
|
¢
. In this case repeat the pro-
|
¢
|
|
¢
16
Locating a handset ("paging")
You can locate the handsets using the base station.
Precondition: base station is in idle mode.
¤
Briefly press the paging key
tion.
All handsets will ring using a specific paging melody.
This also applies if the ringer tones are deactivated.
The displays will show
In case of an incoming call, the handset quits the pag-
ing mode and then rings.
After 30 seconds handset and base station go back to
idle mode.
Ending paging manually
¤
Briefly press the paging key
tion again.
Making internal calls
Internal calls are free calls to other handsets that are
registered to the same base station or to the base sta-
tion itself.
Making internal calls (handset)
Calling another internal participant
~
k
¢
(enter internal number of participant)
0 = base station, 1-4 = handset number, * = all
If only 1 handset is registered you need not enter a
number to call the handset from the base.
Accepting internal call
¤
To answer the call press
¤
To end the call, press
Incoming call during internal call
c
An incoming call is indicated by an acoustic signal.
k
(answer external call, end internal call) or
k
¢
(hold internal call, accept external call)
(start conference)
Internal consultation calls
When you are speaking to an external participant,
you can call an internal participant at the same time
k
for consultation.
~
k
Press and hold
¢
(enter internal number of participant)
k
You are connected with the internal participant.
(toggle between internal and external partici-
pant)
Ë
on the base sta-
.
INTERCOM X
Ë
on the base sta-
c
a
.
.
(put external call on hold)
Advertisement
Chapters
Table of Contents
