Advertisement
Status Window
The STATUS window, available on some models, indicates the following activity:
1-24h
Number of delay start
hours. The last hour will
count down in minutes.
MINUTES
Number of minutes left in
cycle (1-199).
User Instruction Code
Instruction
Problem/Condition
Code
Displayed
Close
This indicates the
door has been left
open or not properly
latched.
PF
Soft Power Failure: PF is displayed if a power outage occurs during
a wash cycle. The wash cycle will be paused temporarily and resume
once power is restored if the door has not been opened.
Hard Power Failure: A hard power failure means the unit will not
operate until power is restored. Pressing start within 18 hours of loss of
power will resume power at the point of cycle interruption.
Error Code
Displayed
Problem
Error Code*
i10
A low fill has been
detected.
i20; i40; iF0 Clogged filters or a
restricted drain line
has been detected.
i30
A leak or overflow
of water has been
detected in the
bottom pan.
i50
A problem has been
detected with the
drain or wash motor.
i60
A problem has been
detected with the
water heating system.
iC0
A problem has been
detected with the
electronic control system.
*In all Error Code instances, if Pressing the cancel button or turning power off at the
breaker for 5 min. does not resolve the problem, contact the Frigidaire Customer Care
Center at 1-800-944-9044.
OPERATING INSTRUCTIONS
CLOSE
L0–L6.
Solution
Ensuring the door is properly latched will clear
the display. This does not indicate a problem
with your dishwasher and service will not need
to be contacted.
Solution
Look for a pinched water supply line, or
water shutoff is not completely opened.
Check and clean both filters and sump
area and check for a pinched or blocked
drain hose. If the drain line is attached to a
disposer, check that the knockout plug has
been removed.
Look for loose connections at the water inlet
valve and ensure the unit is properly leveled.
Pressing the cancel button or turning power
off at the breaker for 5 min. should clear this
error code and the unit can be restarted.
If this does not resolve the problem,
service will need to be called.
Close will scroll across the status
window indicating the door
needs to be closed.
Level of Rinse Aid dosage.
7
Advertisement
