Advertisement
Loading the Silverware Basket
CAUTION
Load sharp items (knives, skewers, etc.)
pointing down.
Failure to do so may result in injury.
Features and appearance of racks and
silverware basket may vary from your
model.
Load the silverware basket while it is in
the bottom rack or take the basket out
for loading on a counter or table.
In some models small items like baby
bottle caps, jar lids, corn cob holders, etc.,
can be placed in a covered section. Close
the cover to hold small items in place.
Use suggested loading patterns, as
shown, to increase washability of the
silverware.
•
Be sure nothing protrudes through
bottom of basket or rack to block the
spray arm.
•
Do not mix silver and stainless to
avoid damaging the silver finish
OPERATING INSTRUCTIONS
Mix items in each section of the basket
with some pointing up and some down to
avoid nesting. Water spray cannot reach
nested items.
Adding an article
To add or remove items after wash cycle
starts:
•
•
•
Loading the Cutlery Tray
(If available on your model)
The Cutlery Tray is designed for flatware
and most cooking or serving utensils.
Heavily soiled utensils or items with
baked on foods should be placed in the
upper rack or silverware basket for best
washing performance. The separators
on the cutlery tray help keep flatware
separated to avoid damage and improve
cleaning.
Load cutlery as suggested with cutlery
handles placed inwards to optimize
cleaning performance.
Unlatch door and wait a few seconds
until wash action stops before
opening.
Add the item and wait a few seconds
to allow cold air to slowly expand
inside dishwasher.
To resume cycle press the START/
CANCEL pad and close the door
immediately.
NOTE
11
Advertisement
