Components Of Front Panel - Mosa GE SX-10000 KTDM Use And Maintenance Manual

Pos. Description
Z2 Thermal-magnetic circuit
breaker
D Ground fault interrupter
(30 mA)
Z2 (only for Thermal-magnetic circuit
GE SX-10000) breaker
15 A.C. socket
12 Earth terminal
Z6 Multifunction digital indicator
X9 Controller InteliNano PLUS
B6 Controller power switch
Q1 Starter key
C2 Fuel level gauge
O1 Low oil pressure warning light Indicates the shutdown of the motor due to low oil pressure
F5 High temperature warning
light
M1 Fuel reserve warning light
N1 Battery charger light
I4 Preheating pilot light
59A Engine thermal switch
L5 Emergency button
X1 Remote control socket
D6 PAC (ATS) panel connector
59B AUX thermal circuit breaker
Y5 Voltage selection switch
Function
General switch for the gen-set.
It protects both gen-set and related electrical circuit from over current /
short circuit.
Device for protection against not-direct contacts for TN and TT systems
(neutral grounded to frame)
Protects the system connected to the outlets 230V / 16A from overcurrent
and short-circuit.
AUX sockets for load connection.
Ground connection point for gen-set.
GE voltage VAC - GE Hz Frequency - Total hour counter - Resettable split
time hour counter (for maintenance) - Battery voltage VDC
Starting and stopping the generator. Generator protection, alarms
(shutdowns) and warnings. Motor and generator parameter measures.
History of events and alarms (no. 10). Automatic start (AMF).
Controller power on/off switch.
Starting and stopping key of the generator
Indicates fuel in the reservoir (%).
Indicates the shutdown of the motor due to high temperature of the coolant
Indicates the tank fuel level
Signals a fault in the motor battery charging circuit
If on, indicates the activation of the preheating circuit.
Protection against over-currents and short circuits in the engine electrical
system.
To be pushed in case of danger. Immediate stop of the gen-set.
Connection for TCM35 remote control or for a NO clean contact, both ope-
rating only if EP6 is set to AUTO.
Connection for the PAC (ATS) automatic transfer switch unit.
16-pin connector.
Overcurrent protection of the equipments connected to the single-phase
sockets
Select the output voltage at the sockets.
25
COMPONENTS OF FRONTAL PANEL
M
32