Woodbridge BJ600 Installation And Care Manual
Air and whirlpool heated bathtub
Hide thumbs
Also See for BJ600:
- Installation and care manual (13 pages) ,
- Installation and care manual (13 pages) ,
- Installation and care manual (12 pages)
Table of Contents
Advertisement
INSTALLATION AND CARE GUIDE
AIR AND WHIRLPOOL HEATED BATHTUB
BJ100
Certified to the following Codes & Standard:
• UL 1795 Safety Standard for Hydromassage Bathtubs
• ASME A112.19.7 / CSA B45.10) – Hydromassage Bathtub Systems
• CSA B45.5/IAPMO Z124 – Plastic Plumbing Fixtures
• International Plumbing Code
• International Residential Code
• Uniform Plumbing Code
•
National Plumbing Code of Canada
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
Must hire a licensed electrician to install a dedicated 120V, 30 Amp circuit breaker for the BJ-series-
hardwired 3-in-1whirlpool tubs. The electrician also needs to verify the connected electrical wiring can
handle a 30 Amp current.
WOODBRIDGE is not responsible for product damage/malfunction caused by incorrect electrical installation.
WOODBRIDGE is also not responsible for property damage caused by incorrect electrical installation.
INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING
OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
This products must be installed by a fully insured and licensed plumber only. Installation of any our product by anyone other
than fully insured and licensed plumber shall void limited warranty. We recommen that such licensed plumber has experience
in the installation of products.
We are not responsible for local code compliance for this product. Building and plumbing codes may vary from state-to-state in
accordance to your location. We are not responsible for providing any compliance certifications.
Under no circumstances we shall not be liable for any incidental damages sustained in connection with this product
Neither manufacture, nor distributor, nor retailer is responsible for water damage or flood caused due to use of this product.
Under no circumstances we shall not be liable for any and all fees, cost of installation/reinstallation/removal, subsequent
damage or transportation in case of the product defect
Customer Service Phone: 562-229-0088. (Monday - Friday 9 AM - 5 PM Pacific Time)
WOODBRIDGE
BJ400
BJ500
® (IPC)
® (IRC)
® (UPC)
® (NPC)
Or Email: help@woodbridgebath.com
R
BJ600
2 PEOPLE ARE REQUIRED TO LIFT AND DURING
ENTIRE INSTALLATION OF THIS PRODUCT
BJ700
(UL1795)
20231010 REV. 2
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Woodbridge BJ600
Summary of Contents for Woodbridge BJ600
- Page 1 WOODBRIDGE is not responsible for product damage/malfunction caused by incorrect electrical installation. WOODBRIDGE is also not responsible for property damage caused by incorrect electrical installation. INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT.
-
Page 2: Before You Begin
• All information is based on the latest product information available at the time of ® publication. WOODBRIDGE reserves the right to make changes in product characteristics, packaging, or availability at any time without notice. PRODUCT REQUIREMENTS A. -
Page 3: Installation Requirements
BJ700 71" 44" 6-3/4" 14 1/2" Water depth Heater Air Blower Control box 5-1/8" 60-5/8" 16-1/8" Hydromassage 15" Direct connect Pump to breaker Tub Inline Heater to Maintain Water Temperature* IMPORTANT INFORMATION • Measurements are ± 1/2" and subject to change without notice •... - Page 4 30 Amp current. WOODBRIDGE is not responsible for product damage/malfunction caused by incorrect electrical installation. WOODBRIDGE is also not responsible for property damage caused by incorrect electrical installation. For Air Bath and Whirpool Tub installation, Do not apply any silicone sealant after installation, leave a 5-10mm(0.2"...
- Page 5 WHIRLPOOL & AIR & HEATER 3-in-1 JETTED TUB (for single Hardwired model only) CLARIFICATION: WOODBRIDGE has two types of jetted tubs. This diagram is for the model with all functions combined into one single wire that needs to be hardwired.
-
Page 6: Power / Function
T O HE AT E R L I G H T G ND HE AT E R P UMP B L OWE R 2. Control Panel lcons BJ100 BJ500 BJ600 display window Power Function Right/Up Left/Down OK button Chromo Theraphy light Wave Massage... - Page 7 3. Operating Instruction on Control Panel (1) POWER ON/OFF: Press and hold the power button for 2 seconds to turn it on. Repeat the same operation to turn off the power. (2) CHROMO THERAPHY LIGHT ON/OFF: When power is on keep touching the Left and Right buttons until the cursor on the LCD is on the Chromo Therapy light position , press the OK...
- Page 8 4. Schematic diagram of the panel BJ400 BJ700 Display Window Wave Massage ON/OFF Air Blower ON/OFF Bottom light ON/OFF Power ON/OFF switch Thermostate (1) Press the Power switch , to turn on the power. (2) Press the Bottom Light , switch to turn on and off the lights. (3) Press the Air Blower , to turn on and off the air blower.
-
Page 9: Operating Environment
5. Operating Environment (1) Power: AC 110V (2) Bottom Lights: AC 12V (3) Wave massage, Air Blower: AC 110V (4) Heater: AC 110V 6. Caution 1. Carefully read this user manual before you operate this unit and keep this user manual for future reference. 2. -
Page 10: Installer Information
NOTES NOTES INSTALLER INFORMATION INSTALLER INFORMATION DATE OF INSTALL: DATE OF INSTALL: INSTALLER’S NAME: INSTALLER’S NAME: PLUMBER: PLUMBER: CONTRACTOR: CONTRACTOR: LICENSE #: LICENSE #:... -
Page 11: Warranty
Improper care and use of abrasive cleaners and will void the warranty. During this limited warranty period if a malfunction occurs and after inspection it is determined that a defect developed during normal use, Woodbridge will as at... - Page 12 Abrasive sponges or cloth. Never use steel, wool, or wired brushes that will permanently scratch the surface. Retain these installation instructions for future reference! Thank you for using WoodBridge products! Please don't hesitate to contact us if you have any questions or concerns.
Need help?
Do you have a question about the BJ600 and is the answer not in the manual?
Questions and answers
what are the specific difference between the BJ 500, BJ600 and the BJ700
Based on the provided information, the specific differences between the Woodbridge BJ500, BJ600, and BJ700 models are:
1. Water Depth:
- BJ500: 14 1/2"
- BJ600: 13 3/4"
- BJ700: Not specified in the context
2. Dimensions:
- All three models (BJ500, BJ600, BJ700) appear to have similar overall dimensions: 72" x 35-3/8"
3. Pricing and Discounts:
- BJ500: Sale price $2199 (original $3690), saving $1491 (40%)
- BJ600: Sale price $2184 (original $2749), saving $565 (21%)
- BJ700: No pricing details provided
4. Model Features:
- All come with a hydromassage system, adjustable speed air blower, heated soaking, and display control panel.
- Additional variations (e.g., with tub filler) are available for BJ500 and BJ600. No such info for BJ700.
5. Standards and Codes:
- All BJ-series models, including BJ500, BJ600, and BJ700, are certified to UL1795, ASME A112.19.7 / CSA B45.10, CSA B45.5/IAPMO Z124, IPC, IRC, UPC, and NPC.
6. Installation Requirements:
- All require a hardwired 120V, 30 Amp dedicated circuit.
There is no unique specification or feature listed for BJ700 in the provided context.
This answer is automatically generated