Preparing The Remote - Hunter Deermont PG3869 Instruction Manual

1886
The remote control is
already paired for use.
For your convenience, a
remote function card is
packed in with your remote.
Battery
Door
Phillips
Head
Screw
You have two options for installing the remote cradle.
Choose which path works best for you.
Option 1: Using Adhesive Strip
Separate the lining
from the back of the
Remove the cradle from
adhesive strip on
the cradle bracket.
the cradle bracket.
9
Ceiling Bracket Downrod

Preparing the Remote

To access the battery
compartment, remove the
small Phillips head screw that
secures the battery door to
the transmitter assembly. The
battery should be installed
with the positive (+) side
up. Replace with a CR2032
battery when necessary.
Installing the Remote Control Cradle
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Hanging Fan Wiring
ON
NOTICE
To enable dimming, your remote must be set to
Dimming Mode. To toggle Dimming Mode on or off,
long press the "Fan Speed Up" button and "Fan
Speed Down" button.
Option 2: Using Screws
Choose your cradle
installation location.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Canopy Blades
: DIMMING MODE
Slide the cradle onto
the mounted bracket.
Light Bulbs Remote Remote Cradle