Table of Contents
Advertisement
1886
The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
NOTICE
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Replace all batteries of a set at the same
time.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove batteries from equipment which
is not to be used for an extended period
of time.
• Remove used batteries promptly.
You have two options for installing the remote cradle.
Choose which path works best for you.
Option 1: Using Adhesive Strip
Separate the lining
from the back of the
Remove the cradle from
adhesive strip on
the cradle bracket.
the cradle bracket.
9
Ceiling Bracket
Downrod
Preparing the Remote
To access the battery
compartment, remove the
small Phillips head screw that
secures the battery door to
the transmitter assembly. The
battery should be installed
with the positive (+) side
up. Replace with a CR2032
battery when necessary.
Battery
Door
Phillips
Head
Screw
Installing the Remote Control Cradle
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Hanging Fan
Wiring
Remote Function Guide
Key Press
+ Quick Press
+ Long Press
+ Quick Press
+ Quick Press
+ Quick Press
Long Press
Long Press
Long Press
Long Press
Long Press
Option 2: Using Screws
Choose your cradle
installation location.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Canopy
Blades
Function
Light On/Off
Light Dimming
Fan On/Off
Raise Fan
Speed
Lower Fan
Speed
+
Fan Updraft
Fan Downdraft
+
+
Enable Beep
+
Disable Beep
+
Dimming Mode
On/Off
ON
Slide the cradle onto
the mounted bracket.
Light
LED/Glass
Remote
Advertisement
Table of Contents
