Hunter Deermont PG3869 Instruction Manual page 9

1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
To install the glass, first loosen the thumb screws.
Raise the glass to the light fixture. Tighten all
thumbscrews securely.
Repeat x3
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs
fan without the light kit?"
Ceiling Bracket Downrod
2 of 6
Light Kit Screw
bag
5
Partially install two of the light kit screws
found in the
notches in the sides of the lower switch
housing with the screws on the upper
switch housing. Twist the lower switch
housing clockwise to lock into place.
Installing the Bulbs and Glass
Note:
and click "How do I install my
Hanging Fan Wiring
Assembling the Light
2
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
2 of 6
Light Kit Screw
bag
hardware bag. Align the
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x3
Fan style may vary.
Canopy Blades
3
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
6
Install the last light kit screw.
Tighten all three screws securely.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light Bulbs Remote
1886
1 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
8
Remote Cradle