Related Manuals for EMG SA/SA/85 Set
Summary of Contents for EMG SA/SA/85 Set
- Page 1 Инструкция по использованию комплекта гитарных звукоснимателей EMG SA/SA/85 Set (на английском языке)
-
Page 2: Specifications
Warranty All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This warranty covers only those pickups and accessories sold by authorized EMG Dealers. -
Page 3: Position Switch
2) Some instruments may already have a battery holder installed and in that case soldering may be required, see page 3. Installing EMG Combination Systems is very easy and is accomplished in a few steps. The controls included have a 10 mm bushing height so they can be used either on a pickguard, or body mount. - Page 4 If your instrument has a 9 or 18-Volt battery holder you can still needs to be mounted in the Jack plate. Mount the Jack onto the plate use the EMG Connectors to supply power to the pickups. with the orientation as shown with the Tip spring pointing down.
-
Page 5: Output Jack
Step Six: 1) Plug the Output Cable from the PC Board (GND/SIG) to the Volume Control. 2) Plug the Output cable from the Output Jack onto the Volume control as shown. 3) Plug the green wire onto the Ring terminal of the Switch PC Board. GREEN WIRE TO THE RING TERMINAL PIN OF THE PC BOARD FROM...
Need help?
Do you have a question about the SA/SA/85 Set and is the answer not in the manual?
Questions and answers