Preoperational Instructions; Shutdown Instructions - Maytag MDG31PDAWW Installation & Operator's Manual

Preoperational Instructions __________

Important
!
For more detailed information regarding the
microprocessor controller (computer), refer to the
microprocessor user's manual included with the dryer.
Coin Models
Microprocessor Controller (Computer)
When the microprocessor controller (computer) is in the ready
state, the L.C.D. screen will display "Ready, Insert $XX.XX
(amount) to Start".
Insert coin(s). Once the correct "Amount to Start" has been
inserted, the L.C.D. will display "Select Temperature".
Select temperature by pressing "HI," "MED," or "LO." The
cycle will start and the L.C.D. will display the Dry Cycle selected
and the remaining time.
The dryer will continue through the drying and cooling cycles,
until the vended time has expired.
Note
!
To stop the dryer, open main door. Continuation of
the cycle will resume only after the door has been
closed and any one of the 3 temperature selections is
pressed.
Non-Coin Models
Microprocessor Controller (Computer)
The L.E.D. display reads "READY" (no cycle in progress).
Press the letter on the keypad corresponding to the cycle
desired (e.g. key "D").
The dryer will then start (i.e. blower, tumbler, and heat).
The L.E.D. display will read MANUAL DRYING CYCLE D,
___MIN REMAIN.
Note
!
The dryer can be stopped at any time by pressing
the "STOP/CLEAR" key, at this time the dryer will
go into a cycle pause. If the "STOP/CLEAR" key is pressed
again at this point, the cycle that was in progress will be
cancelled and returned to the "READY" state.
When the programmed drying time has expired, the non-coin
microprocessor controller (computer) will proceed into the
Cool Down Cycle.
Once the Cool Down Cycle begins at the end of the heat
cycle, the L.E.D. display will read COOL DOWN TEMP ___/
___ MINUTES remaining. At the end of the heat cycle, the
dryer will shut off the heat and continue the fan and tumbler
until the Cool Down Time or temperature is reached.
28

Shutdown Instructions ________________

If the dryer is to be shutdown (taken out of service) for a
period of time, the following must be performed:
Discontinue power to the dryer either at the external disconnect
switch or the circuit breaker.
Discontinue the heat supply:
Gas Models – Discontinue the gas supply.
Shut off external gas supply shutoff valve.
Shut off internal gas supply shutoff valve located in the gas
valve burner area.
NOTES ____________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
___________________________________________
Maytag Co. 113430-3