Rigging Instructions; Rigging Cable - Work Pro SN SUB 8 SoundNut Series User Manual

SN SUB 8
USER MANUAL
VERSION 1.2

6. RIGGING INSTRUCTIONS

SN SUB 8 uses a quick and simple solution that allows its installation in a wide variety of facilities, using
a keyless release mechanism.
To install the SN SUB 8 correctly, two CS 10 E cables must be used, one as main rigging cable, and
one as safety cable. The cables are included in the SN SUB 8 system.
CS 10 E is a 5m long with a Gripple® loop end fixing, steel cable. The cable also includes an additional
Gripple® locking device to ensure the rigging position.
Quick adjustment, CS 10 E does not require tools for adjustment.

Rigging cable

Pass the loop end over
the building feature.
Adjust the desired height
by pressing the button
and sliding the locking
device at the same time.
SN SUB 8
+
Thread the tail wire
through the loop to
create a choke knot.
Pass the tip of the wire
through the central hole of
the hanging point of SN SUB
8.
www.workpro.es
Pass the tip of the wire
through a hole in the
Gripple® locking device.
Pass the tip of the wire
through the free hole in the
Gripple® locking device.
Ensure a minimum 75mm
of tail wire exit the hanger.
7