Table of Contents
Advertisement
3.3 FITTING
The appliance can be fi tted in the newly-built or existing chimney breast of an open fi re.
When fi tting, both fi re safety and operational safety must be safeguarded. The fi tter is
responsible for this.
General guidelines:
• If there is a wooden beam above the fi tting location, heat must not radiate directly
onto it. An insulation plate must be hung below the beam, leaving an air gap between
it and the beam of at least 1 cm.
• Always use (white) unbound ceramic insulation wool. Bound material (yellow), such
as glass and rock wool, spreads an irritating smell on heating, causes excess smoke
and is unsuitable for high temperatures.
Insulation requirements:
•
Have any electrical connection for the convection fan carried out by a professional
electrician.
Note ! :
The fan should be connected to an earthed wall socket.
This socket must remain accessible at all
•
Before fi tting, remove the door to protect the glass.
Do not use masking tape on the appliance when installing
and plastering.
Tape can damage the fi nish of the appliance.
22
• temperature resistance ≥ 700°C.
• density ≥ 80 kg/m
times.
UNIVERSAL-6 85
3
Installation instructions
Advertisement
Table of Contents
