LG 60PX4DR Training Manual page 51

CIRCUIT DESCRIPTIONS
SIGNAL CONTROL
Signal processing (Contour noise, reduction) controls the state of each FET on each DRIVER B/D with
R, G, B each with 8bit input (Uses 3.3V/5V 2 kinds of power ). This PCB controls all aspects of the
PDP panel. This PCB also digitally segments the panel and controls the pixels and cells as if the panel
was a large memory IC and changes the data as needed after screen by screen comparison. The data
that differs from one frame to another are the addresses that are reset and changed. The software in
this PCB differs greatly from the software in the Digital PCB.
MCM
Buffer
IC
Array저항
16 line
16 line
16 output
51
Plasma Training Adjustments