LG 60PX4DR Training Manual page 20

OPERATION
color is set too high, predominant colors, such as red, will bloom and bleed, causing white to
appear pink, and yellow to appear orange. When color is set too low, the entire image will appear
more gray than colored, with the extreme lower limit resulting in a Black & White picture. To
properly set the Color Level, lower the color setting to the point where colors begin to appear gray.
Next, begin stepping up the color level until the primary and sub-primary colors begin to exceed
their normal color representations.
Tint – The Tint control is used adjust the Hue of the display between red or green. The proper
setting for tint is, as with the color setting, to the point where the primary (red, green, & blue)
and sub-primary (yellow, cyan, & magenta) colors appear as their pure, natural colors without
bleeding into other colors. The extreme settings of tint will result in a red/magenta overall hue or
a green/cyan overall hue. To properly set the Tint control, adjust towards red if yellows appear with
a green tint or towards green is yellows appear with a red or orange tint.
NOTE: The Color and Tint controls interact with each other. The current color setting will affect
the hue and the current tint setting will affect the saturation. Therefore, you may need
to readjust the color setting after adjusting the tint setting, and likewise readjust the tint
setting after subsequent color settings. Keep repeating the adjustment until the best
color representation is reached.
TIP: After Color and Tint adjustments are completed, reds may over saturate slightly, causing
yellows to appear orange. You may need to slightly reduce the color level to compensate
for this effect.
Sharpness – The Sharpness control is used to adjust the amount of data added to the display
image. When the sharpness control is set too high, white or jagged edges will appear on black lines
or the edges of objects. When the sharpness control is set too low, the edges of objects or black
lines will appear fuzzy. To properly set the Sharpness control, adjust the setting up or down until
black lines have crisp, clean edges, while maintaining the overall brightness level across the image.
TIP: If a noticeable difference is not seen during the sharpness adjustment, simply place the
control at the 50 mark.
1. Press MENU on the Remote Control or Front Controls
2. Use the / buttons to highlight the VIDEO Menu (2
3. Use the /
/
4. Use the
5. Press ENTER to save the selection
6. Use the /
7. Press EXIT to completely exit the On-Screen Menu or MENU to return to the previous
menu.
Color Temperature – The Color Temperature control is used to adjust the color of gray on the
display between red and blue tint. The Cool setting will provide a slightly blue tint to the picture.
The Warm setting will provide a slightly red tint to the picture. Once the previous adjustments have
been made, the color temperature may be changed for personal preference.
Video Reset
The Video Reset option will revert all video menu options to their factory preset values. The EZ
Picture function will revert to the Daylight setting and the custom settings are the same as Normal.
Plasma Training
buttons to highlight the desired control and press
buttons to adjust the control
buttons to change to another control or
nd Menu) and press
20
Operation