General Power Tool Safety Warnings; Work Area Safety - Parkside PDSSA 20-Li A1 Translation Of The Original Instructions

Use only the following high-speed battery
charger to charge the cordless tool:
PLG 20 A1
INPUT:
Rated voltage:
Rated power
consumption:
Fuse (internal):
OUTPUT:
Rated voltage:
Rated current:
Charging time:
Protection class:
Noise emission value:
Noise measurement value determined in accord-
ance with EN 60745 . The A-rated noise level
of the tool is typically:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Vibration emission value:
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Tightening screws and nuts of maximum
permissible size:
a = 8,65 m/s
2
h
Uncertainty K = 1 .5 m/s
Wear hearing protection!
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons . The
specified vibration emission value can also
be used to make an initial exposure estimate .
PDSSA 20-Li A1
230–240 V ~ , 50 Hz
(AC)
65 W
T3.15A
3 .15 A
21 .5 V (DC)
2 .4 A
approx . 60 min
II / (double insulation)
L = 91,6 dB (A)
PA
K = 3 dB
PA
L = 102,6 dB (A)
WA
K = 3 dB
WA
2
WARNING!
► The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions
in some cases . Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration . Try to keep the vibration
loads as low as possible . Measures to reduce
the vibration load are, e .g . wearing gloves
and limiting the working time . Wherein all
states of operation must be included (e . g . times
when the power tool is switched off and times
where the power tool is switched on but
running without load) .
General Power
Tool Safety Warnings
WARNING!
► Read all safety warnings and all instructions .
Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or
serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents .
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .
15 ■
GB│IE │