Installing The Starter Rope; Filling The Engine With Oil - Toro Recycler 20795 Operator's Manual

3. Attach the handle ends to the mower housing with
2 washers and 2 handle bolts (Figure 4), but do not
tighten the handle bolts.
1. Washer
2. Handle bolt
Important: Route the cables to the outside of
the handle (Figure 4).
4. Rotate the handle rearward (Figure 5).
Figure 4
3. Handle end
Figure 5
5. Lock the handle at your desired height. Refer to
Adjusting the Handle Height in the Operation
section.
6. Torque the handle bolts to 120 to 160 in-lb (14 to
17 N-m).
7. Adjust the cutting height. Refer to Adjusting the
Cutting Height.
2

Installing the Starter Rope

No Parts Required
Procedure
Pull the starter rope through the rope guide on the
handle (Figure 6).
1. Starter rope
3

Filling the Engine with Oil

No Parts Required
Procedure
Your mower does not come with oil in the engine.
1. Remove the dipstick (Figure 7).
6
Figure 6
2. Rope guide