Assembling And Unfolding The Handle - Toro Recycler 20795 Operator's Manual

112-8867
1. Lock
114-7982
1. Warning—read the Operator's Manual.
2. Thrown object hazard—keep bystanders a safe distance
from the machine.
3. Cutting/dismemberment hazard of hand or foot, mower
blade—remove the ignition key and read the instructions
before servicing or performing maintenance.
4. Cutting/dismemberment hazard of hand or foot, mower
blade—stay away from moving parts.
5. Cutting/dismemberment hazard of hand or foot, mower
blade—do not operate up and down slopes; operate side to
side on slopes; stop the engine before leaving the operating
position; and look behind you when backing up.
115-8411
1. Unlocked
2. Unlock
2. Locked
Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling and
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Install the blade control bar into the upper handle
(Figure 3).
2. Raise the rear of the mower housing to its highest
cutting height setting by moving the 2 rear cutting
height levers all the way forward. Refer to Adjusting
the Cutting Height in the Operation section.
5
Figure 3