Table of Contents
Advertisement
Appliance details
3.3.2 Remove front cover
▶ Loosen the two Phillips head screws located on bottom rear
of cover.
Fig. 3
Loosen the two screws
▶ Lift front cover panel upward and remove.
Fig. 4
Remove the front cover
12
3.3.3 Remove combustion cover (service only)
▶ Open the four clips and remove the combustion cover.
Fig. 5
Remove the combustion cover
3.4
General rules to follow for safe operation
•
1. You must follow these instructions when you install your
heater. In the United States: The installation must conform
with local codes or, in the absence of local codes, the
National Fuel Gas Code ANSI Z223.1/NFPA 54.
In Canada: The Installation must conform with CSA
B149.(1,2) INSTALLATION CODES and /or local
installation codes.
•
2. Carefully plan where you install the heater. Correct
combustion air supply and vent pipe installation are very
important. If not installed correctly, fatal accidents can
occur, such as carbon monoxide poisoning or fire.
•
3. When the unit is installed indoors and ROOM SEALED
(twin pipe) it is permitted to be located in bathrooms,
bedrooms and occupied rooms that are normally kept
closed. See chapter 4.3 (page 15). If the unit will be
installed indoors and use indoor combustion air, the place
where you install the heater must have enough ventilation.
The National Fuel Gas Codes do not allow UNSEALED
gas fired water heater installations in bathrooms,
bedrooms or any occupied rooms normally kept closed.
See chapter 4.4 (page 38).
•
4. You must correctly vent your heater. See chapter 4.3
(page 15) on VENTING.
C 950/C 1050 (Pro TL 175 C/199 C) – 6 720 805 440 (2019/10)
6720644956-11. 1 V
Advertisement
Table of Contents
