Partially Arming The System - Partial Mode; Disarming - From The On Or Partial Mode - Hills NX-1516 User Manual

PARTIALLY ARMING THE SYSTEM –
Partial arming allows you to temporarily exclude some rooms from security arming. For
example, you may wish to exclude bedrooms at night when they are in use. Partial mode is
also used for protecting exterior doors and windows (the home perimeter) when the user is
inside.
Partial is used when the user is inside the premise and wants protection around the
perimeter. Listed below are the steps to arm in the Partial mode:
Close all protected doors and windows. Ready light will light when all protected zones and
1.
sensors are secure. NOTE: If any zones are bypassed, a sensor in that zone can be violated
without affecting the ready light. The security system will not arm if the ready light is not on. If
the power light is off, you have no AC power. Restore power if possible. If not, contact your
installation company.
Press the [PARTIAL] key. The bypass light will illuminate if any zone(s) is bypassed. The
2.
light(s) corresponding to the bypassed zone(s) will illuminate, alerting the user that a zone(s)
may be unprotected and can be faulted without an alarm.
Key Sequence
PARTIAL
DISARMING –
When you enter the protected area through one of the designated Entry/Exit doors, the code
pad control will sound a solid continuous tone for the duration of the entry delay time, or until
you enter a valid code. After entering a valid code the red armed light will go off and the tone
will stop. The security system is now DISARMED. If a valid code is not entered before the
end of the entry delay, an alarm will occur. (NOTE: If the red armed light is flashing during
the entry delay, the alarm system has been activated in your absence. Leave the building
immediately and call your alarm company and/or the police from a safe location.)
Key Sequence
ON
FROM THE
Page 8
PARTIAL MODE
Operation
Press the Partial key to partially arm
your premises
Partial
OR
Operation
Enter your user code to disarm the
system from the On or Partial mode.
MODE
V2.02