Table of Contents
Advertisement
FULLY ARMING THE SYSTEM –
ON is used when the user is away from the premise and wants the interior protected. To arm
in the ON Mode:
1.
Close all protected doors and windows. Ready light will light when all protected zones and
sensors are secure. NOTE: If any zones are bypassed, a sensor in that zone can be violated
without affecting the ready light. The security system will not arm if the ready light is not on. If
the power light is off, you have no AC power. Restore power if possible. If not, contact your
installation company.
Enter your 4 digit user code to arm the system. The armed and exit lights will illuminate. You
2.
may now leave the building via the designated exit path.
Note: The exit light will flash rapidly for the last 10 seconds of the exit delay as a warning to
the user that the exit time is about to expire.
Key Sequence
FULLY ARMING THE SYSTEM –
Quick Arm is used when the person arming the alarm system does not have a user code, is
leaving the premises and wants the interior protected. To arm in the Quick Arm Mode:
1.
Close all protected doors and windows. Ready light will light when all protected zones and
sensors are secure. NOTE: If any zones are bypassed, a sensor in that zone can be violated
without affecting the ready light. The security system will not arm if the ready light is not on. If
the power light is off, you have no AC power. Restore power if possible. If not, contact your
installation company.
The [ON] key to arm the system. The armed and exit lights will illuminate. You may now
2.
leave the building via the designated exit path.
Note: The exit light will flash rapidly for the last 10 seconds of the exit delay as a warning to
the user that the exit time is about to expire.
Key Sequence
ON MODE
Example shows a User code of 1234
being used to set the system to the
ON Mode.
QUICK ARM MODE
Example shows ON key being used
to set the system to the Quick Arm
Mode.
Page 7
Operation
Operation
V2.02
Advertisement
Table of Contents
