Code Pad Control Tones - Hills NX-1516 User Manual

CODE PAD CONTROL TONES

•
Beeps for all key presses Sounds a continuous tone during the entry delay time.
•
Pulses when a day zone is violated while the system is disarmed.
•
Pulses when a fire zone has a trouble condition.
•
Beeps 3 times for trying to arm with the "Ready" light off, if "Force Arming" has not been
selected.
•
Beeps for 1 second or emits a "ding-dong" sound for the "Chime" feature.
•
Beeps during an exit delay; beeps rapidly for the last 10 seconds of an exit delay; and
beeps 1 second at the end of the exit delay.
•
Pulses when the armed status changes and the AC power is off.
•
Pulses when the armed status changes and any zone(s) is bypassed.
•
Pulses when the armed status changes and a low battery is detected.
•
Pulses when the armed status changes and a tamper condition is detected. Beeps to
indicate telephone line cut, if selected.
•
Pulses when one or more of the following conditions are detected: zone or box tamper,
low battery, AC power fail, or expander trouble.
Entering a valid code will silence the code pad sounder when it is pulsing. Please
contact your installer if a trouble condition exists.
Page 6
V2.02