Deleting User Code; Walk Test - Hills NX-1516 User Manual

DELETING A USER CODE
You may be required to delete a user code, for example, when a member of the household
leaves home, or the home is purchased from another family.
Key Sequence
5
*
2
1
0 3
CHIME CHIME
#

WALK TEST

Walk test is used to test the functionality and should be performed regularly. When in walk
test mode the code pad transmits the chime sound each time a zone is activated, and will
light the activated zone number in the code pad for the duration of the walk test period. You
must exit the walk test mode when you have completed testing or are satisfied the zones
function correctly.
Note: the alarm system will not report to the control room during the walk test.
Key Sequence
4
3
CHIME CHIME
1. Press [*] [5].
2. Enter an existing master code.
3. Enter the user code to be deleted
(e.g. user code 03)
4. Press the [Chime] key four (4)
times to delete the user code.
5. Repeat steps 3 and 4 for
additional user codes.
6. Press [#] when completed.
1. Press [*] [CHIME].
2. Enter a master code. The system
is now in walk test mode.
3. Walk past each motion sensor and
return to the code pad to check each
zone light to validate the sensors are
working correctly.
4. Enter a master code to exit walk
test. If no master code is entered,
walk test mode will automatically exit
in 15 minutes.
Page 12
Operation
Operation
V2.02