Table of Contents
Advertisement
Section 3 - Configuration
This page will allow you to change the administrator (Admin) password
and enable the HTTPS service. Go to Management > System Admin. To
configure the System settings, click the System tab. Refer to System on
page 75.
Admin Password
Password
Enter a new password for the administrator account. You will need to
enter this password whenever you configure the device using a web
browser or add the device to EAGLE PRO AI.
Advanced Settings - Administration
Enable HTTPS
Enable HTTPS to connect to the extender using an encrypted connection.
Instead of using http://XXXX.devicesetup.net/ (where XXXX represents
Management
the last four digits of the device's MAC address), you must use https://
XXXX.devicesetup.net/ in order to connect to the device.
Note: If you previously changed the management link in the Network
section, replace XXXX.devicesetup.net/ with the new management link
(refer to Settings > Network).
Enable HTTPS
Remote management allows the device to be configured over the
Remote
Internet via a web browser. A password is still required to access the web
Management
configuration interface.
D-Link M15 User Manual
System Admin
Admin
73
Advertisement
Table of Contents
