Daily Inspection - BorMann PRO BWR2511 Manual

EN

5. Daily Inspection

This chapter describes pre-shift checks before putting the truck into operation. Daily inspection is effective to find the malfunction or fault on the truck and
can maximize the lifetime. Check the truck on the following points before operation.Remove load from truck and lower the forks to the lowest position.
Do not use the truck if any malfunction or fault is found.
Visually check for structural deformation or cracks of arms, forks, or any other component; and unusual noise or binding of the lifting mechanism.
Check if there is any oil leakage.
Check the vertical creep of the lifting mechanism.
Check the smooth movement of the wheels.
Check if there are any particles or damages on the wheels.
Check if all the bolts and nuts are tightened firmly.
If equipped, check the brake. Verify that all labels are in place.
6. Οperating Instructions
WARNING:
When operating the truck, the operator has to wear safety shoes.
The truck is intended to be used for indoor applications with ambient temperatures between +5 C and + 40 C.
O O
The operating lighting must be minimum 50 Lux.
It is not allowed to use the truck on angled surfaces.
Never leave a loaded pallet truck unattended.
A. Parking
Lower the forks to the lowest position and park the Hand pallet truck on a smooth and even level ground where the truck not disturbs any other opera-
tions. If equipped with a brake use the brake for parking the truck acc. to the description further below.
B. Lifting
Check that the load does not exceed the loading capacity of the pallet truck. Roll the pallet truck with its forks slowly under the pallet/load until the back
end of the fork rests against the load (Fig.6). Shift the operating lever down to the Lifting position. Lift the load by up- and down movements of the tiller
arm.
The load must be evenly distributed across both forks. DO NOT OVERLOAD THE TRUCK!
Fig. 6
C. Lowering
Do not put foot or hand under the lifting mechanism. Lower the load by shift the operating lever up to the lowering position carefully. By releasing the
lever, the lowering movement will stop. Ensure there is adequate clearance behind, then move the pallet truck away.
D. Moving
Do not operate the truck on a slope or inclined surface.
Watch difference of floor level when moving lifter. Load could fall down.
Make the load stable to prevent it from falling down.
The truck might be not equipped with a brake. In this case the braking distance is longer and depends on the operator.
If equipped, release the brake. Move the truck by pushing or pulling the tiller arm. The tiller arm is connected to the steering rollers. The wheels are steered
automatically by moving or steering the tiller arm.
E. Malfunctions
If there are any malfunctions or the truck is inoperative, please stop using it, place the truck at a safe place. Avoid further usage. Inform immediately the
manager and, or call your service.
5
WWW.NIKOLAOUTOOLS.GR