Warnings And Safety Instructions - BorMann PRO BWR2511 Manual

EN

3. Warnings and Safety Instructions

DO NOT: Allow other person then the operator to stand in front of or behind the truck when it is moving or lifting/lowering.
Overload the truck.
Put foot in front of rolling wheel, Injury could result.
Use the truck on a slope or inclined surface, the truck may become uncontrollable and create danger.
Lift or carry people. People could fall down and suffer severe injury.
Use truck with unstable, unbalanced loosely stacked load.
Use the truck in explosive atmospheres.
Watch difference in floor levels when moving the truck. Load could fall down or the truck could get uncontrollable. Keep watching the condition of load. Stop
operating table if load becomes unstable. Practice maintenance work according to regular Inspection. This truck is not designed to be water resistant, therefore
use it in dry atmospheres.
4. Commissioning, Transporting, Storage / Reassembling
A. Commissioning – Tiller assembling: after receiving our new hand pallet truck you may have to do following before firstly operating the truck:
• Check if are all parts included and not damaged
• Do the work according to the daily inspections as well as functional checks.
• Eventually assemble the truck according to following instructions.
The commissioning weight is approximately. 10kg / six- pack higher than the product weight. Before assembling, please make sure, that the following supplied
parts are included and not damaged:
• 1 pc axle with hole (4)
• 2 pc dowel pin (5) [one is already assembled with the axle]
• 1 pc pre- assembled tiller arm (1)
• 1 pc pre- assembled chassis with pump unit (6). Note: The marked number on the tiller arm package and the chassis should be the same.
1 Tiller arm
2 PIn
3 Nut
4 Axle with hole
5 Dowen pin
6 Chassis with pump unit
3
WWW.NIKOLAOUTOOLS.GR
Fig. 2