Assembly And Adjustments - Tool Shop 240-2003 Operator's Manual

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, never connect plug to power source
outlet until all assembly steps are completed.
Base to column (See Fig. 1)
1. Place Colum n (1) on the Base (3) and align holes
in the Column with holes in the Base.
2. Attach using Bolt, Spring Washer, and Washer
(2) in each hole through the Column and into the
Base.
Table to column (See Fig. 2)
1. Loosen the Lock handle (3) on the table. (2).
2. Slide the Table(2) over the Column ( 1 ).
3. Tighten the Lock handle (3) to secure the Table (2)
in place.
Drill press head to column
1. Lift the drill press head assembly (1) carefully and
place the mounting hole of the drill press head onto
the top of the column (3). Make sure the head is
seated properly on .
2. Align the direction of the drill press head to the
direction of the base and the table.
3. Tighten the set screws (2) using the 5/32" hex wrench.
4. Thread the handle rods (4) into the holes on the hub.
5. Hand tighten.
Note: One or two of the handles may be removed
- shaped workpiece interferes with handle
unusually
rotation.
5
(See Fig. 3)
1
2
3
1
2
3
1
2
3
if an
4
Fig 1 1 Fig. 1 1
Fi Fig. 2
Fig. 3