Operation - Tool Shop 240-2003 Operator's Manual

ASSEMBLY AND ADJUSTMENTS
11. If the quill (8) returns gently to top position (correct operation):
‡ Tighten the inner nut (4). Do not overtighten.
‡ Replace the jam nut (3). Tighten against the inner nut.
‡ Remove the screwdriver.
‡ Rotate the handles and check the quill (8) for unrestricted
movement.
12. If the quill (8) movement is too restricted or tight:
‡ Loosen the jam nut (3).
‡ Slightly loosen the housing inner nut (4).
‡ Tighten the jam nut (3).
‡ Check the quill (8) movement again and repeat steps 1-3
until the quill (8) moves freely.

OPERATION

Risk of injury due to accidental starting. Do not use in an
WARNING:
area where children may be present.
Safety Switch: Insert the Safety Key (Fig 12) into the Switch. This
"Key" is a safety precaution and should remain in the Switch during
use and be removed after Switch is turned off and/or any time the
Drill Press is left unattended or in storage.
TURNING ON AND OFF
Note:
The pulley cover must be closed to operate the drill press.
1. Switch the drill press on by pressing the "ON" button on the
switch. (F ig 12).
2. Switch the drill press off by pressing the "OFF" button on
(Fig 12).
the
switch.
3. Secure your workpiece to the table if possible, using a vice or
clamps.
9
!
ON
Safety
Key
OFF
Fig. 12