Tool Shop 240-2003 Operator's Manual page 3

SAFETY PRECAUTIONS FOR DRILL PRESS
!
IMPORTANT SAFETY INSTRUCTION
14. DRESS PROPERLY. Don't wear loose clothing or jewelry; they can be caught
in moving parts. Protective, non-electrically conductive gloves and non-skid
footwear are recommended when working. Wear protective hair covering to
contain long hair and keep it from harm.
15. USE EYE PROTECTION. Use a full-face mask if the work you're doing produces
PHWDO ¿OLQJV GXVW RU ZRRG FKLSV Goggles are acceptable in other situations.
Wear a clean dust mask if the work involves creating a lot of ¿ne or coarse
dust.
16. SECURE WORK. Use clamps or a vise to hold the work. It's safer than using
your hands and it frees both hands to operate the tool.
17. DON'T OVERREACH. Keep proper footing and balance at all times. Do not
reach over or across tools that are running.
18. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and safe performance.
Follow instructions for lubricating and changing accessories. Keep handles dry,
clean and free from oil and grease.
19. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position
before plugging in.
20. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES before turning the tool on. Left attached, these parts can Ày
off a rotating part and result in personal injury.
21. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF. Have
your tool repaired before using it.
22. DISCONNECT THE PLUG FROM POWER BEFORE MAKING ANY AD-
JUSTMENTS. Changing attachments or accessories can be dangerous if the
tool could accidentally start.
23. STAY ALERT. Watch what you are doing & use common sense. Don't operate
any tool when you are tired.
24. CHECK FOR DAMAGED PARTS. Before using this tool, any part that is dam-
aged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mountings, and other conditions that may
affect its operation. Inspect screws and tighten any ones that are loose. Any
part that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in the instruction manual.
Have defective switches replaced by an authorized service center. Don't use
the tool if switch does not turn it on and off properly.
25. REPLACEMENT PARTS. When servicing, use only identical replacement parts.
26. SERVICE AND REPAIRS should be made by quali ¿ ed repair technicians at an
authorized repair center. Improperly repaired tools could cause serious shock
or injury.
WARNING: Do not operate your drill press until it is completely
assembled and installed according to the instructions.
1. Never turn on the drill press before clearing the table of all objects (tools,
scraps, etc.).
2. Always keep hands and fingers away from the drill bit.
3. Do not drill material that does not have a flat surface, unless a suitable
support is used.
4. Never start the drill press with the drill bit pressed against the workpiece.
5. Make sure the table lock is tightened before starting the machine.
2