Mounting - Boss Audio Systems ELITE HARLEY-DAVIDSON BEHDX98 User Manual

Mounting

See the section "Installation Precautions".
Disconnect the negative terminal of the vehicle battery prior to installation.
Install the unit where it does not interfere with your driving.
If you must modify the vehicle for the installation, make sure you do not impair the safety and
structural integrity of the vehicle.
Before you drill or cut any holes, investigate your vehicle's layout very carefully. Take special care
when you work near the fuel tank, fuel lines, hydraulic lines and electrical wiring.
Mount the Unit
This unit is designed to replace your factory stereo, and use your existing factory wire harness to plug and play.
1.
Finish wiring connection to the unit.
2.
Power on the unit. Perform a function test to ensure
correct operation.
3.
Access the factory fairing stereo opening. Correctly place
the unit in the opening, Secure the unit on both sides using
four factory bolts.
Ensure the unit is firmly attached to avoid vibration while
riding.
Make sure connection cables are not pinched or damaged
by sharp objects or moving parts.
Mount a Dedicated Amplifier (Optional)
This unit is equipped with a fixed OEM style mounting bracket that can be used to secure a third-party
accessory such as a dedicated amplifier (BOSS model BHD3F - sold separately) on top of the unit.
What You Need
• Make sure your Harley-Davidson
has sufficient factory stereo opening space
(minimum 4.6"/115mm height) to mount a
dedicated amplifier on top of this unit.
• Purchase the product (BOSS model BHD3F)
which comes with the dedicated amplifier and
two speakers.
• Mount the dedicated amplifier on top of this
unit. For mounting instructions, refer to the
Installation Instructions provided with BHD3F.
(P.5)
motorcycle
®
- 6 -
A dedicated
amplifier (BHD3F)
4.6"
(115mm)