Table of Contents
Advertisement
Mounting On Dashboard
See the section "Installation precautions" on page 2.
Use only installation parts provided with the product. Using other mounting
methods may void the warranty.
Before you drill or cut any holes, investigate your vessel's layout very carefully.
Take special care when you work near the gas tank, fuel lines, hydraulic lines
and electrical wiring.
1.
Cut a mounting hole (Ф 3.13" / 79.5 mm) in the dashboard.
2.
Slip the unit through the mounting hole in the dashboard.
1
Ø 3.13" / 79.5 mm
3.
Fasten the unit to the dashboard with the supplied
U-bracket and two bolts and nuts.
If needed, remove one or more break-away tabs
on the U-bracket to shorten the bracket for firm
fastening to the dashboard.
Wiring
See the section "Installation precautions" on page 2.
Disconnect the negative terminal of the vehicle battery prior to wiring.
Connect the unit to a 12V DC battery and negative ground only.
Connect speaker wires to speakers with 4 - 8 Ω .
Never ground or short the speaker wires.
Insulate all bare wires and unconnected wires with electrical tape.
2
5
3
Break-away
tabs
Advertisement
Table of Contents
