Accessory Power Control
The unit can connect and power control the connected accessories (not included, e.g. light bars or whips). The
accessories load is rated at 350 mA.
1.
Connect your external accessories to the unit through the unit's wires marked "DC12V-1" (brown) or marked
"DC12V-2" (brown/white). See the section "Wiring" on page 5.
2.
To turn on or off the connected accessories, press
1 and 2. Rotate the function knob to select the power button option, then press the function knob to enable
or disable the power output.
Audio Output
You can output audio from the unit to an external amplifier.
1.
Using RCA audio cables (not included), connect the RCA audio outputs (labeled Front Line Out L/R, Rear
Line Out L/R, SUB-W Out) on the unit to the RCA audio inputs on an amplifier (not included). See the
section "Wiring" on page 5.
2.
Start playback on this unit and audio will output to the connected amplifier.
Troubleshooting
If you have problems using this product, check the following points before you request service. If you still have
a problem, contact our Customer Service for further assistance.
Problem
Unit not responsive
No power
No sound
Restart the unit by turning the vehicle off for a few seconds, then turning the
vehicle back on.
If the problem still persists, disconnect the unit from the source battery for a
few minutes and then reconnect.
This unit is powered through connection to your Harley-Davidson
wiring harness. Connect the factory harness to this unit for power supply.
Check that the power/ignition/ground wire of your Harley-Davidson
are correctly connected.
Check that the vehicle ignition power (ACC) is switched on.
Check that playback is not paused, or turn up the volume.
Incorrect source input. Press SOURCE to select the correct source.
Check that the connected speakers are not faulty.
- 16 -
on the front panel to display the power button option
Solution
factory
®
harness
®