Shutting Down - Man D 0836 LE 401 Operating Instructions Manual

The following light-emitting diodes function continuously:
D Power on:
D Ignition:
D Serial data activity:
If the following light-emitting diodes light up, there is a fault
D Diagnostic unit failure:
D Sensor failure
D Speed sensor failure:
D Remote slow down:

Shutting down

Do not switch off engine immediately operation at high loads, but let it idle for about 5
minutes to achieve a temperature equalisation.
Set deck switch to "Neutral" and switch off the engine at the ignition key.
Remove key from starting lock.
Danger:
Ensure that the engine cannot be started by unauthorized persons
Commissioning and operation
Diagnosis unit is receiving voltage
Ignition is on
Data interchange at the bridge.
If this fails, no more data is displayed on the bridge, neither
on the display (Display MMDS-D08/L /LC).
The diagnosis unit is defective
A sensor is defective. The measurement point of the
defective sensor flashes with the same frequency as
"Sensor failure"
Defective engine speed input
Remote reduction of speed.
Alarm at other engine. The defective engine reduces the
intact engine.
This prevents a curving manoeuvre in the case of an alarm.
56