Serial/Parallel Port Configuration Submenu; Serial Port Configuration Submenu - National Instruments PXI-8119 User Manual

Hide thumbs Also See for PXI-8119:
Table of Contents

Advertisement

Chapter 2
Installation and Configuration
In addition, the following option is available for each detected device if a
USB mass storage device is present:

Serial/Parallel Port Configuration Submenu

Use this submenu to apply alternate configurations to the serial and
parallel ports. Normally, you do not need to modify these settings, as the
factory default settings provide the most compatible and optimal
configuration possible.

Serial Port Configuration Submenu

NI PXI-8119 User Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
delay value is taken from the hub descriptor. The default value for this
setting is Auto.
Device Power-Up Delay in Seconds—This setting specifies the
number of seconds the Power-On Self Test will wait for a USB device
or hub to power on. This setting is only visible if Device Power-Up
Delay is set to Manual. The default is 5 seconds.
Emulation Type—This setting specifies how the BIOS will present
the USB mass storage device to the system. This option can be used to
present a USB mass storage device as a floppy, Zip, hard disk, or
CD-ROM drive. The default is Auto, which allows the BIOS to treat
small USB flash disk drives as floppy drives and larger USB flash disk
drives as hard disk drives.
Serial Port Configuration—Use this setting to access the Serial Port
Configuration submenu. Refer to the Serial Port Configuration
Submenu section for more information.
Parallel Port Configuration—Use this setting to access the Parallel
Port Configuration submenu. Refer to the
Configuration Submenu
section for more information.
Serial Port—This setting enables or disables the onboard serial port.
The default value is Enabled.
Device Settings—This item displays the current base address and
interrupt request level (IRQ) information for the onboard serial port.
Change Settings—This setting changes the base address and interrupt
request level (IRQ) information for the onboard serial port. The default
value is Auto.
2-10
Parallel Port
ni.com

Advertisement

Table of Contents
loading

Table of Contents