F&F BIS-410-24V Manual

Bistable relay with timer

BIS-410

Bistable relay

with timer

Do not dispose of this device in the trash along with other waste!

According to the Law on Waste, electro coming from households free of charge and can

give any amount to up to that end point of collec� on, as well as to store the occasion of

the purchase of new equipment (in accordance with the principle of old-for-new, regard-

less of brand). Electro thrown in the trash or abandoned in nature, pose a threat to the

environment and human health.

Purpose

Electronic bistable pulse relay BIS-410 allows switching on or off

the lighting or other device from several different points by pa-

rallel connected, momentary (bell) control switches.

The receiver is switched on after a current pulse caused by pres-

sing any momentary (bell) button connected to the relay.

The receiver is turned off after the next impulse or automatically

after the set off time.

A longer pressing of the momentary button (lasting at least 2

seconds) turns on the relay permanently.

The relay will be turned off only after pressing the momentary

button again (or after a power failure).

F&F Filipowski sp. j.

Konstantynowska 79/81, 95-200 Pabianice, POLAND

phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71

www.fif.com.pl; e-mail: biuro@fif.com.pl

24 V

- 1 -

Table of Contents

Do you have a question about the BIS-410-24V and is the answer not in the manual?

Page 1 F&F Filipowski sp. j. Konstantynowska 79/81, 95-200 Pabianice, POLAND phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71 www.fif.com.pl; e-mail: biuro@fif.com.pl BIS-410 24 V Bistable relay with timer Do not dispose of this device in the trash along with other waste! According to the Law on Waste, electro coming from households free of charge and can give any amount to up to that end point of collec�...
Page 2 Mounting 1. Disconnect the power supply. 2. Mount relay in the flush-mounted box. 3. Connect the power supply cables to PWR group: (+)-wire to terminal 5 or 6, (–)-wire to terminal 3 or 4. 4. Momentary switches connected in parallel connect to terminal 1 and (+)-wire.
Page 3 control input relay output (–) power supply (+) power supply Technical data power supply 9÷30 V AC/DC contact 1×NO maximum load current (AC-1) 16 A activation delay 0,1÷0,2 s switch-off time (adjustable) 1÷15 min. power indication green LED power consumption standby 0.15 W 0.7 W...
Page 4 Warranty The F&F products are covered by a warranty of the 24 months from the date of purchase. Effective only with proof of purchase. Contact your dealer or directly with us. CE declaration F&F Filipowski sp. j. declares that the device is in conformity with the essential requirements of The Low Voltage Directive (LVD) 2014/35/EU and the Electromagnetic Compatibility (EMC) Directive 2014/30/UE.

Bis-410