HUSKY LINERS BELMOR BFM1004M2 Care And Use Instructions

FLOOR LINERS BY BELMOR
CARE AND USE INSTRUCTIONS PN: BFM1004M2
Thank you for selecting Belmor Floor Liners. Your new floor liners are custom molded to fit your
truck. The liners are designed to fit directly on the floor any existing mats must be removed
before installation. Do not install any other mats on top of these liner.
Your liners are made from an engineering resin that is lightweight and extremely tough and
durable. The easiest way to clean your liners is with a damp cloth or sponge and soap and
water. Windex®, 409® and ArmorAll® type cleaners work as well.
TO INSTALL YOUR LINERS, POSITION THEM IN YOUR CAB AS SHOWN ABOVE. THIS LINER SET INCLUDES
THE LINERS ARE DESIGNED TO OVERLAP
EACH OTHER
LINER. IN THIS CONFIGURATION THE PIECES FORM A CONTINUOUS LINER.
DEPENDING ON THE OPTIONS INCLUDED IN YOUR TRUCK, TRIMMING OF THE LINERS MAY BE REQUIRED
TO ACHIEVE THE PROPER FIT. TRIM INFORMATION IS INCLUDED ON THE BACK OF THIS PAGE.
ONCE THE LINERS ARE INSTALLED AND BEFORE OPERATING VEHICLE, CHECK CONTROL PEDAL
OPERATION (CLUTCH, BRAKE, ACCELERATOR) TO MAKE SURE THAT THE LINERS ARE NOT INTERFERING
WITH SAFE OPERATION OF THE VEHICLE. IF THERE IS ANY QUESTION ABOUT SAFE OPERATION,
REMOVE LINERS AND CALL BELMOR CUSTOMER SERVICE AT 800-344-8759 FOR ASSISTANCE.
View the Belmor Liner Warranty at www.huskyliners.com/lifetime-warranty
BFM1004M2_03/24/20