Ieee 802.1Q Tagged Vlan Commands; Configuring Tagged Vlan - ZyXEL Communications ZyXEL Dimension ES-2024 User Manual

IEEE 802.1Q Tagged VLAN
This chapter describes the IEEE 802.1Q Tagged VLAN and associated commands.

34.1 Configuring Tagged VLAN

The following procedure shows you how to configure tagged VLAN.
1 Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the
switch.
• Use the
switch automatically enters the
deactivate the VLAN(s).
• Use the
interface mode to set the VLAN settings on a port, then use the pvid <vlan-id>
command to set the VLAN ID you created for the port-list to that specific port in the
PVID table.
• Use the
sysname(config)# vlan 2000
sysname(config-vlan)# name up1
sysname(config-vlan)# fixed 10-12
sysname(config-vlan)# no untagged 10-12
sysname(config-vlan)# exit
sysname(config)# interface port-channel 10-12
sysname(config-interface)# pvid 2000
sysname(config-interface)# exit
2 Configure your management VLAN.
• Use the
managing the switch, and the switch will activate the new management VLAN.
• Use the
sysname(config)# vlan 3
sysname(config-vlan)# inactive
Chapter 34 IEEE 802.1Q Tagged VLAN Commands
command to configure or create a VLAN on the switch. The
vlan <vlan-id>
config-vlan
interface port-channel <port-list> command
command when you are finished configuring the VLAN.
exit
command to create a VLAN (VID 3 in this example) for
vlan <vlan-id>
command to disable the new management VLAN.
inactive
ES-2024 Series User's Guide
C
H A P T E R
Commands
mode.Use the
3 4
command to
inactive
to enter the config-
240