Before Asking For Repair Service - Luxman D-07X Manual

Before Asking for Repair Service

While in use, this unit may display phenomena which may be confused as malfunctions. Before contacting your country's official
LUXMAN distributor for repair services, please read the operating instructions for any connected input and output devices and check
the troubleshooting table below. If the cause of the malfunction cannot be identified, please contact your dealer. After LUXMAN's
representatives have accepted your request for repair services, inspection fees and transportation expenses may be claimed, even
though the unit may be found to be operating normally.
Besides, such personal computer as a PC/Mac connected to the unit and the software that operates on the PC/Mac (operations and
settings included) are not supported.
Problem
No power is supplied.
The disc tray comes out even
after the tray is closed.
Playback cannot be performed.
No sound is generated. / Sound
volume is too low. (Digital input)
The remote control cannot be
operated.
An electronic device such as a
television malfunctions.
43
Cause/Solution
• Connect the power cable to the AC inlet and the AC outlet firmly.
• Place the disc on the disc tray correctly.
• Clean the disc to remove dirt.
• Clean the disc to remove dirt.
• Place the disc on the disc tray correctly.
• Remove condensation from the interior of this unit.
• Place the disc on the tray with the label facing upwards. (label face
upward)
• Connect digital cables correctly.
• If USB is selected as an input source, select this unit (D-07X) as the
output destination by configuring the sound setting of your PC/Mac.
• If the unit (D-07X) cannot be selected even when trying the solution
above, disconnect, then reconnect the USB cable.
• If USB is selected as an input source, adjust the sound volume by
configuring the sound setting of your PC/Mac.
• If USB is selected as an input source, adjust the sound volume on
your PC/Mac player software.
• Ensure that this unit supports the sampling frequency and the
quantization bit rate of the desired digital input signal.
• Check to see whether digital input "UNLOCK" is displayed or not.
(When a digital signal from a digital device is not synchronized with
this unit, the source may not be played back.)
• Operate the remote control within the specified operating range.
• Replace the remote control batteries with new ones.
• The remote control infrared receiver is exposed to direct sunlight or
strong light sources (such as inverter fluorescent lights).
Change the installation place or angle to avoid the exposure to
strong light sources.
• Some devices equipped with a wireless remote control receiver may
malfunction when the remote control of this unit is operated. Keep
this unit away from such devices.
Ref. page
20
24
2
2
24
1
19 - 20
Refer to the
instruction manual of
the PC/Mac or the
software in use.
18
10
9
10
10