Samsung AC TN4PKC Series Instruction Manual page 24

Installation Procedure
3 Check whether the option values that you have set are
correct by pressing the
[SEG2, SEG3] [SEG4, SEG5]
[SEG11, SEG12] [SEG14, SEG15]
[SEG21, SEG22] [SEG23, SEG24]
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor
on the indoor unit and then press the
button on the remote control twice. Make sure that
this command is received by the indoor unit. When it is
successfully received, you can hear a short sound from
the indoor unit. If the command is not received, press
the (Power) button again.
5 Check whether the air conditioner operates in
accordance with the option values you have set:
a Reset the indoor or outdoor unit.
• Indoor unit : Press the
buttons on the remote control simultaneously for
4 seconds.
• Outdoor unit : Press the K3 button.
b Remove the batteries from the remote control,
insert them again, and then press the
button on the remote control.
AR-EH0**, AR-EC0** remote controls
Entering the
mode for setting
the options
High Temp button
Low Temp button
24
English
(Mode) button repeatedly
[SEG6, SEG8] [SEG9, SEG10]
[SEG16, SEG17] [SEG18, SEG20]
(Power)
(Set) and (Option)
(Power)
Setting the
option values
Mode button
High Fan button
Low Fan button
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
2 Set the option values.
CAUTION
• The total number of available options are 24: SEG1 to
SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
• Set a 2-digit value for each option pair in the following
(High Temp) and