Remote Level Control (Optional) - JL Audio NexD M1000/1v2 Owner's Manual

REMOTE LEVEL CONTROL (OPTIONAL)

With the addition of the optional Remote
Level Control (HD-RLC), you can control the
subwoofer volume from a location of your
choosing.
The HD-RLC connects to the jack labeled
"Remote Level Control" on the Connection Panel
of the amplifier using a standard telephone cable
(supplied with the HD-RLC). If desired, multiple
XD (and HD) amplifiers can be controlled from
a single HD-RLC controller using a simple phone
line "splitter" and multiple phone cables.
When connected to the amplifier, the
HD-RLC operates as follows. At full counter-
clockwise rotation, the audio will mute
completely. At full clockwise rotation the level
will be the same as if the HD-RLC was not
connected at all. In other words, it operates
strictly as a level attenuator.
PREOUTS
The M1000/1v2 incorporates a pass-through
preamp output section, so that additional
amplifiers can be easily added to the system.
The preamp output delivers the same signal that
is connected to the M1000/1v2's inputs.
The preamp output signal by any crossover
filter selected (if the input signal is full-range, the
preamp output will be full-range).
If you plan to use the "Preouts" to feed
a stereo amplifier, you must connect a
stereo signal to the input of the amplifier.
A mono signal into the amplifier will result
in a mono signal out of the preamp output.
9