Monoblock class d marine subwoofer amplifier (21 pages)
Summary of Contents for JL Audio M400/4
Page 1
For maximum performance, we highly recommend that you have your new amplifier installed by an authorized JL Audio dealer. Your authorized dealer has the training, expertise and installation equipment to ensure optimum performance from this product.
The outer shell of your JL Audio amplifier is the event of a collision or a sudden jolt to the vessel. such high sound pressure levels when connected Do not attempt to “bridge”...
M600/4 is the the vessel and your body during installation. be protected with a high quality rubber The M400/4 can be operated with a wide only device being run from the fused main grommet to prevent damage to the variety of source units and system configurations.
If you wish to send four discrete channels into you can then adjust any or all “Input Sens.” the M400/4, simply use all four inputs and set the levels downward if this is required to achieve the “Input Mode” switch in the “4 Ch.” position.
JL Audio dealer so functioning normally, audio output is active. that it may be sent in to JL Audio for service. When a pair of the M400/4’s channels are There are no user serviceable parts or fuses inside...
For precise filter frequency right and dedicated subwoofer outputs. Inp ut Connections: The main stereo pair a system with a single M400/4 are explained in The second stereo pair of source unit outputs information refer to Appendix B (page 15).
Page 8
C: input sensitivity level setting 9) Once you have adjusted the M400/4 to its Precise Frequency selection Chart m400/4 specifications Following the directions below will allow the maximum low-distortion output level, “Filter Freq” installer to adjust the input sensitivity of each reconnect the speaker(s).
Please refer to Appendix A (page 14) to set the input sensitivity for Check your voltage source and grounding point. The power supply maximum, low-distortion output. of the M400/4 will operate with charging system voltages “my amplifier doesn’t turn on.” down to 10V. Shutdown problems at higher volume levels Check the fuse, not just visually, but with a continuity meter.
Page 10
Use this diagram to document your amplifier’s switch and control positions. 18 | JL Audio - M400/4 Owner’s Manual...
Page 11
All warranty returns should be sent to JL AUDIO ’s Amplifier Service Facility freight-prepaid through an authorized JL AUDIO dealer and must be accompanied by proof of purchase (a copy of the original sales receipt). Direct returns from consumers or non-authorized dealers will be refused unless specifically authorized by JL AUDIO with a valid return authorization number.