300w full-range class d monoblock amplifier (8 pages)
Summary of Contents for JL Audio M 1700
Page 1
For maximum performance, we highly recommend that you have your new amplifier installed by an authorized JL Audio dealer. Your authorized dealer has the training, expertise and installation equipment to ensure optimum performance from this product.
1 inch (2.5 cm) of space above the amplifier’s outer shell to permit Cooling Efficiency Considerations: proper cooling. The outer shell of your JL Audio amplifier is designed to remove heat from the amplifier Safety Considerations: circuitry. For optimum cooling performance,...
PRODUCT DESCRIPTION 4) Connect negative power wire to the negative The JL Audio M1700 is a monoblock subwoofer amplifier utilizing proprietary and battery post. Use the same size power patented Class D technology. Its frequency wire as the wire connected to the “+12V”...
MaxiFuse™ type. the terminal block, seating it firmly so that no bare wire is exposed. While holding the wire in place, tighten the set screw firmly, taking care not to strip the head of the screw. JL AUDIO M1700...
“Input Range” switch is placed in the “High” position. Conversely, the output will be higher with the switch in the “Low” position. While this may sound counter-intuitive, it is consistent with the descriptions above. JL AUDIO M1700...
Keep in mind that turning the internal connect an optional remote boost knob (sold crossover off also defeats the “Bass Boost” separately as JL Audio Model RBC-1) that processing (see next section for details). With can be mounted near the head unit. With the internal crossover turned off, the M1700’s...
While holding the wire in place, tighten the set screw firmly, taking care not to strip the head of the screw. JL AUDIO M1700...
Page 10
The amplifier will continue to operate and return to normal power output once its temperature returns to a normal range. JL AUDIO M1700...
Page 11
If your amplifier fails or malfunctions, please return it to your authorized JL Audio dealer so that it may be sent in to JL Audio for service. There are no user serviceable parts or fuses inside the amplifier. The unique nature of the circuitry in the JL Audio amplifiers requires specifically trained service personnel.
Page 12
7) Connect the AC voltmeter to the speaker output connectors of the amplifier. Make sure you test the voltage at the correct connectors (+ and –). 8) Increase the “Input Sens.” control until the target voltage is observed with the voltmeter. JL AUDIO M1700...
Check the input connectors to ensure that they all are making good contact with the input jacks on the amplifier. JL AUDIO M1700...
Page 15
The speaker wire connectors are designed to accept up to 8 AWG wire. Make sure to strip the wire to allow for a sufficient connection with the metal inside the terminal block. JL AUDIO M1700...
Page 16
INSTALLATION NOTES: Use this diagram to document your amplifier’s switch and control positions. Pre-Outs CH 1 (Left) Input Voltage Power Protect Low | High Bass CH 2 (Right) JL AUDIO M1700...
Page 17
Bass Boost Controls Filter Freq. (Hz) Bass Boost Input Sens. LP Filter mote s Port JL AUDIO M1700...
Page 20
All warranty returns should be sent to JL AUDIO’s Amplifier Service Facility freight-prepaid through an authorized JL AUDIO dealer and must be accompanied by proof of purchase (a copy of the original sales receipt). Direct returns from consumers or non-authorized dealers will be refused unless specifically authorized by JL AUDIO with a valid return authorization number.