Operation - Homelite HPW2201 Operator's Manual

ASSEMBLY
WARNING:
If any parts are missing do not operate this tool
until the missing parts are replaced. Failure to do
so could result in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
NOTE: Do not start the pressure washer until the engine has
been filled with oil and all hoses are connected. Running this
machine without oil will damage the engine while running it
without water will damage the high pressure pump.
CAUTION:
Any attempt to start the engine without adding oil
will result in engine failure.
WARNING:
Petrol and its vapours are highly flammable and
explosive. To prevent serious personal injury and
property damage, handle petrol with care. Keep
away from ignition sources, handle outdoors only,
do not smoke while adding fuel, and wipe up spills
immediately.

OPERATION

WARNING:
Always wear safety goggles or safety
glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
ENGLISH
WARNING:
Do not direct discharge stream at persons. Failure
to heed this warning could result in serious injury.
If the appliance is connected to potable water mains,
backflow prevention devices should be incorporated in or
fixed to the water supply system. The installation should
be accepted by local boards or water supplier and should
be conducted by professional technical personnel. The
backflow prevention devices should be appropriate to
fluid categories and comply with the requirement to avoid
backsiphonage.
When connecting the appliance to the water supply
mains, please observe the local regulations of local
boards or local water supplier. To ensure that there is
no feedback of contaminant into the water supply, the
appliance must not be connected directly to the public
drinking water supply mains.
APPLICATIONS
This product has been designed for the purposes listed
below:
Removing dirt and mould from decks, cement patios,

and house siding.
Cleaning cars, boats, motorcycles, and grills.

STARTING / STOPPING THE PRESSURE WASHER
(Fig 9.)
CAUTION:
Do not run the pump without the water supply
connected and turned on.
Before starting the engine: (Fig 4 - 10.)
Connect all hoses.

Check all fluids (oil and gas).

Turn the garden hose on then squeeze the trigger to

relieve air pressure; hold the trigger until a steady
stream of water appears.
To start the engine: (Fig.11)
Push primer bulb 3 times.

NOTE: If starting the engine for the first time, push

the primer bulb 5 times.
Grasp the recoil starter and pull slowly until

resistance is felt.
Give the start recoil short, brisk pulls to start the

engine.
To stop the engine:
On the top of the engine is the OFF (O) switch. Press the
switch in the OFF position. (Fig 12.)
6