Homelite HPW2201 Operator's Manual page 10

STORING THE PRESSURE WASHER
It is important to store this product in a frost-free area.
Always empty water from all hoses, the pump, the fuel
tank, and the detergent bucket before storing.
NOTE: Use of a fuel stabilizer and pump saver will
give you better performance and increase the life of the
machine.
Discharge Fuel:
Drain the fuel tank completely. Stored petrol can go stale
in 30 days.
Engine Oil:
Drain the oil and replace with fresh, clean oil.
Spark Plug:
Disconnect spark plug wire and remove the spark

plug. Pour about a teaspoon of clean, air-cooled,
four-stroke oil through the spark-plug hole into the
combustion chamber.
Leaving the spark plug out, pull the starter cord two

or three times to coat the inside of the cylinder wall.
Inspect the spark plug and clean or replace, as

necessary.
Reinstall the spark plug, but leave the spark plug

wire disconnected.
Air Filter:
Clean the air filter.

Hoses and pump:
Flush the injection hose with clean water for 1 - 2
minutes. Remove all hoses. Empty the pump by pulling
on the recoil starter about 6 times. This should remove
most of the liquid from the pump.
PREPARING FOR USE AFTER STORAGE
Pull the recoil starter grip three or four times to clean

oil from the combustion chamber.
Remove spark plug from the cylinder. Wipe oil from

the spark plug and return it to the cylinder.
Reconnect the spark plug wire.

Refuel the machine as described earlier in the

operator's manual.
ENGLISH
9