Related Manuals for Homelite HPW2600
Summary of Contents for Homelite HPW2600
- Page 1 HPw2600 Petrol Powered HigH Pressure Cleaner oPerator's Manual original instruCtions Important! It is essential you read the instructions in this manual before starting and operating this machine. Subject to technical modifications.
- Page 2 ■ Check damaged parts. Before further use of the general safety rules tool, a guard or other part that is damaged should be carefully checked to determine that it will operate warning properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, read and understand all instructions.
-
Page 3: Special Safety Rules
poorly ventilated area. sPeCial safety rules ■ never store the machine with fuel in the fuel tank ■ never direct a water stream toward people or pets, inside a building where ignition sources are present, or any electrical device. such as hot water and space heaters, clothes dryers, ■... -
Page 4: Product Specifications
Waste electrical products should not be syMBols disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling Safety alert advice. The following signal words and meanings are intended to explain the levels of risk associated with this product. Please read the instructions carefully before starting the machine. -
Page 5: Intended Use
in place. engine specifications on/off switCH Engine model DJ1P70F The on/off switch is used in combination with the starter Engine type 4-stroke Air- cooled grip and rope to start the engine. It is also used to turn the engine off. Bore and stroke 70 mm / 45 mm starter griP witH roPe... -
Page 6: Installing The Handle
26. Run installing tHe Handle 27. Slot See Figure 3. 28. Nozzle 29. Quick-connect collar to install the handle: 30. Detergent container ■ Push and hold the button on the handle as you slide the handle into the holes in the frame. asseMBly note: Before use, pull the handle up until the lock button snaps through the locking slot to secure the handle in... -
Page 7: Operation
ConneCting garden Hose warning Pressure wasHer Never direct a water stream toward people or pets, or See Figure 9. any electrical device. Failure to heed this warning could The water supply must come from the mains. NEVER result in serious injury. use hot water or water from ponds, lakes, etc. - Page 8 the unit is sitting on a flat, level surface. If the engine is hot, Caution let the pressure washer cool before adding fuel. Always fill the fuel tank outdoors with the machine turned off. If the engine does not start after each pull of the starter grip with rope, squeeze the trigger to relieve water note: Use unleaded petrol only.
- Page 9 or large surfaces), 0˚ Red (for spot cleaning or high-to- wasHing witH detergent reach areas), and Low Pressure Black (for detergent See Figure 15. application and rinsing). Use only detergents designed for pressure washers; house hold detergents, acids, alkalines, bleaches, warning solvents, flam mable material, or industrial grade solutions can damage the pump.
-
Page 10: General Maintenance
noZZle MaintenanCe MaintenanCe Excessive pump pressure (a pulsing sensation felt while squeezing the trigger) may be the result of a clogged or warning dirty nozzle. When servicing, use only original manufacturer’s ■ Turn off the pressure washer and shut off the water replacement parts. -
Page 11: Pump Lubrication
warm but not hot. Warm lubricant will drain quickly and recoil starter about 6 times. This should remove most of the liquid from the pump. more completely. ■ After the crankcase is completely drained, return the PreParing for use after storage pressure washer to an upright position. -
Page 12: Periodic Maintenance Schedule
PeriodiC MaintenanCe sCHedule Maintenance items each use 20 hours 50 hours Check for leakage and loose parts Check and refill engine lubricant Change engine lubricant * Clean spark plug Clean air cleaner Replace air cleaner element Clean fuel cap Clean and adjust spark plug and electrodes Replace spark plug Remove carbon from cylinder head ** Check and adjust valve clearance **... -
Page 13: Troubleshooting
trouBlesHooting ProBleM Cause solution 1. No fuel in tank 1. Fill tank. Engine fails to start 2. Spark plug shorted or fouled 2. Replace spark plug. 3. Spark plug is broken (cracked 3. Replace spark plug. porcelain or electrodes broken) 4. - Page 16 techtronic industries (australia) Pty. ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia techtronic industries new Zealand ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand 20150122v1...