Table of Contents
Advertisement
B. Wiring Requirements
Intellifi re Ignition System Wiring
• Wire the appliance junction box to 110-120 VAC for
proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• Refer to Figure 8.2 and Figure 8.3, Intellifi re Pilot Ignition
(IPI) Wiring Diagram.
• This appliance is equipped with an Intellifi re control valve
which operates on a 3 volt system.
• Plug the 3-volt AC transformer into the appliance junction
box to supply power to the unit OR install two D cell
batteries (not included) into the battery pack before use.
NOTICE: Batteries should not be placed in the battery
pack while using the transformer. Remove batteries before
using the transformer, and unplug the transformer before
installing the batteries. Battery polarity must be correct or
module damage will occur.
Figure 8.2 Intellifi re Ignition Wiring Diagram with Factory-Installed SMART-STAT-II Remote Control
40
PLUG IN
BATTERY PACK
PLUG IN
Heatilator • MDV3732 Installation Manual • 2386-980 Rev. D • 11/16
IGNITION
MODULE 3 VAC
TRANSFORMER
3 VAC
WIRES
(TO BROWN)
INTERMITTENT
PILOT IGNITOR
I
S
ORANGE
WHITE
GROUND TO
FIREPLACE
CHASSIS
VALVE
Advertisement
Table of Contents
