Table of Contents
Advertisement
RF Remote Controller LE60-13/C1
No.
Name
Quantity
2.2 Installing Position and Requirements of RF Remote
Controller
(1)
Please do not install the RF remote controller in the position where is wet or
is likely to be splashed with water;
(2)
Please do not install the RF remote controller near high-temperature
objects or under direct sunlight;
(3)
The RF remote controller should only be installed indoors, and its working
temperature range is 0° C ~ 50° C.
2.3 Installation of RF Remote Controller
Fix it by 3M tape on the wall as shown by the figure as below. The brief
instruction is as below:
(1)
Do not install the button battery before installation;
(2)
Use a tool to gently open the clasp, and then remove the RF remote
controller in the direction of the arrow；
(3)
Use tools to conduct the DIP switch code for RF remote controller
according to room number. Please refer to the schematic diagram of DIP
switch code of RF remote controller for the detailed method;
Table 2.1.1 Introduction of Components
①
wall
/
4
②
3M tape
1
③
RF remote controller
1
Advertisement
Table of Contents
