Table of Contents
Advertisement
Operations
Control panel
01 Cycle Selector
02 Display
03 Temp.
04 Rinse
05 Spin
06 Options
32 English
WW95N64FRPW_DC68-03963R_EN.indd 32
02
07
Turn the dial to select a cycle.
The display shows current cycle information and estimated time
remaining, or an information code when a problem occurs.
For buttons and icons, refer to the corresponding page..
Press to change the water temperature for the current cycle.
Press and hold for 3 seconds to turn on/off the Drum Light.
The drum light turns off automatically after 2 minutes.
Press to change the rinse count for the current cycle. You can set the
rinse count to a max of 5, depending on the cycle.
Press to change the spinning speed for the current cycle. The
revolutions per minute (RPM) differs with the model.
• Rinse Hold(No indicator): The final rinse process is suspended
so that the laundry remains in the water. To unload the laundry,
run a drain or spin process.
- To use the Rinse Hold option, press Spin repeatedly until all
rpm numeric indicators turn off. Not available for the DRAIN/
SPIN cycle.
• Spin Only: To run the Spin Only cycle, press Spin for 3 seconds.
When the cycle time and spinning speed appear, press Spin
repeatedly until a desired spinning speed is selected. Then,
press and hold Start/Pause (Hold to Start) to start the cycle. The
spinning time depends on the selected cycle.
Press to select an option from Intensive and Pre Wash. Press again to
deselect.
08
09
10
03
04
05
06
11
12
2018/11/9 15:12:14
Advertisement
Table of Contents
