Datamax M-Class Mark II Series Operator's Manual page 48

WLAN
MODE
ENABLED
DISABLED
BSS
ADDRESS
SIGNAL
READINGS
IP ADDRESS
SUBNET MASK
GATEWAY
SNMP TRAP
DESTINATION
IP DISCOVERY
ENABLED
DISABLED
SNMP
ENABLED
DISABLED
ADVANCED
TELNET
FTP
MTU
GRATUITOUS
ARP
TCP
KEEPALIVE
ENABLED
DISABLED
PORT
NUMBER
DUPLEX
CAPABILTY
ADVERTISE
CAPABILITY
NETWORK
REPORT
SET FACTORY
DEFAULTS
Chapter 4 – Menu System
Controls the communications settings for the network interface, where:
Selects between wired and wireless operation, where:
Enables the wireless interface. (This is the Default Setting.)
Enables the wired interface.
Specifies the radio module's static IP address; up to four octets separated by a
period. If Enable DHCP is checked, this parameter is ignored. Default is 0.0.0.0.
Provides a graphical representation of Signal Strength (in dBm), Noise Level (in
dBm), and Quality.
Specifies the static IP Address of the interface in the standard octet format.
Specifies the static Subnet assigned to the interface, for example:
255.255.255.000.
Specifies the Gateway Address the interface will use, for example:
010.001.001.001.
Specifies the network IP Address where SNMP traps will be sent when SNMP service
is installed on your receiver. If zeroed, no traps are sent.
Sets the address discovery method, where:
The card broadcasts over the network to receive addresses from the responsible
server at startup. Manual modifications to IP Address, Subnet Mask, or Gateway
Address are not allowed; and, if no server is found, the specified static value will be
used. (Default Setting)

A server assigned IP address takes precedence over any static IP
address stored in the interface.
The stored static IP, Subnet Mask, and / or Gateway Address will be used.
Sets SNMP
(Default Setting)
Advanced settings for the NIC Card.
Enable/Disable Telnet protocol
Enable/Disable FTP protocol
Sets the Maximum Transmission Unit packet size, where:
Packet size, in bytes. (512-65515); Default is 1500
Sets time interval for ARP transmission packets, where:
(0-2048 minutes); Default is 0
Allows monitoring of an open connection to detect any disconnects not properly
closed, including reset access points and unplugged printers, where:
Keeps monitoring active.
Closes such a disconnection after 2.5 minutes. (Default Setting)
Selects the Port to use for all network communications; Default is 9100
Specifies the transmission and speed of the wired Ethernet connection:
Auto-Negotiate (default);
•
100 BaseT Full Duplex;
•
100 BaseT Half Duplex;
•
10 BaseT Full Duplex; or,
•
10 BaseT Half Duplex
•
Selects the method in which the Duplex Capability setting is advertised, where:
Automatic (advertises the DUPLEX CAPABILITY setting); or,
•
All Capabilities (advertises all capabilities)
•
Prints or displays a report which lists the printer's network settings.
Resets NIC Adapter parameters to the factory defaults values.
42